User Manual

4 1
Introduction
Key Digital
®
KD-MAX8x8 is an 8x8 matrix of analog and digital audio. Inputs and outputs support
balanced or unbalanced analog audio on a 6-pin phoenix connector while digital PCM audio
up to 5.1 channels is supported on RCA connectors. Analog and digital outputs may listen to
independent selections of the connected audio sources and each output features a digital signal
processor for volume, muting, 3-band EQ, balance, and delay. Systems greater than 8x8 may be
achieved using multiple units.
Key Features
› Multi-format Audio Multiplexing: DSP per output for independent matrix selection
» Analog to Analog Matrix with DSP
» Digital to Analog Matrix with DSP
» Digital to Digital Matrix
» Analog to Digital Matrix
› Audio DSP: Variable level settings for volume, muting, 3-band EQ, balance, and lip-sync delay
per balanced output
› Audio Delay: Variable level set from 0ms to 170ms
› Audio Conversion: Analog to digital. Digital to analog
› Balanced or Unbalanced: Input audio type may be specified per input
› Lossless Compressed Digital Audio: Dolby
®
and DTS surround up to 5.1ch pass-thru
› Long Cable Runs: Enabled by balanced audio connection, signals may be run up to 1,000 ft.
› Expansion Configurations: Custom configurations available for incrementally expansion using
multiple units
» Up to 8 sources/inputs with up to 64 zones/outputs
» Up to 16 sources/inputs with up to 64 zones/outputs
» Up to 24 sources/inputs with up to 32 zones/outputs
» Up to 32 sources/inputs with up to 32 zones/outputs
› Control Integration: TCP/IP, RS-232, and USB with full bi-directional operation, front panel push
buttons and LEDs, front/rear optical IR, serial IR,
› Control System Support: Key Digital
®
App ready, Compass Control
®
Pro ready, KD-Wizard
®
ready. Fully controllable by all IR, RS-232, and TCP/IP supported control systems via open API:
AMX
®
, Crestron
®
, Control4
®
, KNX
®
, RTI
®
, Savant, URC
®
, Leviton
®
etc.
› Key Digital
®
App Ready: Scan & detect population for pre-built GUI and TCP/IP control via Key
Digital
®
App
Accessories
› Power supply: +12V/2A (25W), model KD-PS12V2ASC
› IR Remote control, model KD-REMOTEHM88
› (17) 6-position terminal block
› Rack mount ears
Rack Mounting
› Secure the included rack ears to each side of KD-MAX8x8 with the supplied hardware, then
fasten the unit to the rack rails with appropriate machine screw.
Note: Please visit www.keydigital.com for the latest product documentation and software
downloads. Product features and specifications are subject to change without notice.
Table of Contents
Introduction ................................................................ 1
Connections, Buttons and LEDs ................................................ 2
Application Example ......................................................... 5
Quick Setup Guide .......................................................... 6
Settings and Adjustments via Remote ............................................ 6
RS-232 and TCP/IP Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Expansion Configurations .................................................... 12
Specifications ............................................................. 13
Important Product Warnings & Safety Instructions .................................. 14
How to Contact Key Digital
®
.................................................. 15
Warranty Information ........................................................ 15
KD-MAX8x8 Manual.indd 4-1 12/23/17 2:18 AM