Specification Sheet

26 | P a g e
Back to top
IGMP Setup Guide: Cisco C3850 Series
4K Systems (KD-IP822/922/1022)
Cisco Catalyst 3850 series
This guide describes how to use Express Setup to initially configure your Catalyst 3850 switch. We have modified
original Express Setup guide from Cisco to help out you install it easily. For more installation and configuration
information, see the Catalyst 3850 documentation on Cisco.com.
Running Express Setup & Configuration Setup for KD-IP822, KD-IP922, KD-IP1022
Use Express Setup to enter the initial IP information. This action enables the switch to connect to local routers and
the Internet. You can access the switch through the IP address for further configuration.
Note : Even you already finish Express Setup on your switch, please check every step one by one.
Step 1
Make sure that nothing is connected to
the switch.
Step 2
During Express Setup, the switch acts as
a DHCP server. If your PC or laptop has a
static IP address, temporarily change
your PC or laptop settings to DHCP.
Note. Do not connect LAN cable from
your PC or laptop to Cisco’s switch until
Step 7.
Step 3
Install the power supply modules. See the “Power Supply Installation” chapter in the Catalyst 3850
Switch Hardware Installation Guide for instructions.
http://www.cisco.com/go/cat3850_hw