Quick Start Guide

2x4/2x8 4K/18G POH/HDBT/HDMI Distribution Ampliﬁer/

Switcher with Audio De-Embedding

(Includes KIT 4/8Rx 100 Meters Extenders)

QUICK SETUP GUIDE

KD-DA2x4G / KD-DA2x8G

CONNECT

Begin with the KD-DA2x4G/KD-DA2x8G unit and all input/output devices turned OFF.

READ PRIOR TO INSTALLATION

1. Connect HDMI sources to the input ports of KD-DA2x4G/KD-DA2x8G unit

2. Connect HDMI displays to the output ports of KD-XDALRx units

3. Connect CAT wires from KD-DA2x4G/KD-DA2x8G’s HDBaseT outputs to

KD-XDALRx HDBaseT input.

4. Connect analog or digital audio outputs to audio system

5. Connect control system and/or PC to TCP/IP, RS-232, or place IR emitter

over IR sensor.

6. To control connected monitors, connect IR/RS-232 pass-thru wiring

from control system into pass-thru ports and from KD-XDALRx to controlling displays

7. Screw-in both power supplies to the KD-DA2x4G/KD-DA2x8G’s unit, and then connect

power to outlets.

8. Power on HDMI sources and displays

PAGE 1
READ PRIOR TO INSTALLATION KD-DA2x4G / KD-DA2x8G 2x4/2x8 4K/18G POH/HDBT/HDMI Distribution Amplifier/ Switcher with Audio De-Embedding (Includes KIT 4/8Rx 100 Meters Extenders) QUICK SETUP GUIDE CONNECT Begin with the KD-DA2x4G/KD-DA2x8G unit and all input/output devices turned OFF. 1 1 1. Connect HDMI sources to the input ports of KD-DA2x4G/KD-DA2x8G unit 2. Connect HDMI displays to the output ports of KD-XDALRx units 2 2 4 4 3 3 3 3 3.
PAGE 2
CONFIGURE Configure and control your KD-DA2x4G/KD-DA2x8G units via Key Digital Management Software™ Pro (KDMS™ Pro) that can be downloaded here: https://goo.gl/ZcyHui 1 2 3 Connect to your unit via TCP/IP port using default static IP address 192.168.1.239, port 23 to a 192.168.1.xxx type network or set your PC to a static IP address of 192.168.1.xxx (excluding .239). Default static IP address: 192.168.1.239, port 23 Open the KDMS™ Pro software and perform a network scan (fig.
PAGE 3
CONTROL 3 (CONTINUED) Option 3: Control via professional control system KD-DA2x4G/KD-DA2x8G allows control over serial interface for bi-directional communication. Default static IP address: 192.168.1.239, port 23 Connection Protocol: Pin: 1 2 ›› ›› ›› ›› ›› ›› 3 Baud Rate = 57,600 bits per second Data Bits = 8 Stop Bits = 1 Parity = Non Flow Control = None Carriage Return: Required at end of string ›› For RS-232 control use pins 1, 2, and 3 of the Main Control port.