Quick Start Guide

6
App Ready Installation with KD Presentation Switcher
KD-CAMUSB may be integrated with compatible Key Digital Presentation Switcher products for a complete
App Ready solution. The current compatible Presentation Switchers are KD-PS42 and KD-UPS52U.
KD-X100MRx
KD-App control
WiFi Network
Network wire
to KD-UPS52U
HDBaseT
TxD+Grnd
to RxD+Ground
KD-CAMUSB
TxD+Grnd
to RxD+Ground
KD-CAMUSB
TxD+Grnd to RxD+Ground HDBaseT Output
IP to RS-232
Conversion
KD-UPS52U
Presentation Switcher KD-PS42 with KD-AMP220
and
/ or
A
B
C
CONNECT
KD-CAMUSB is controlled via RS-232 from the Presentation Switcher (PS). Multiple (up to 7, currently)
KD-CAMUSB units may be installed with App Ready control. Third-party RS-232 repeaters may be required
in systems with more than 2 KD-CAMUSBs.
To connect from the PS’s RS-232 Unit Control port:
» a. Connect wires from the PS’s RS-232 TxD and Ground pins into the KD-CAMUSB’s RS-232 RxD
and Ground pins. See wire in above diagram.
To connect from the PS’s HDBaseT Receiver RS-232 Control port:
» a. Connect wires from the PS’s RS-232 TxD and Ground pins into the PS’s HDBaseT (Output 2) RxD
and Ground pins. See wire
in above diagram.
» b. Connect from the HDBaseT Receiver’s TxD and Ground pins into the KD-CAMUSB’s RxD and
Ground pins. See wire
in above diagram.