LEDpool light Remote Control with built in transformer OWNER’S MANUAL PL-REM-200 Long range DuraLink™ version Controls Spectravision Pool Lights and 2 auxiliary circuits
Table of contents Technical specifications Box contents Installation instructions Pairing Handheld Transmitter & controller Handheld transmitter functions Replacing transmitter battery Troubleshooting page 2 of 8 Page 3 Page 4 Page 5 Page 6 Page 7 Page 7 Page 7
Technical specifications Electrical specifications Nominal Input voltage Output voltage on Lamp Output Max output current on Lamp Output Max rating Relay Contact A and B Resistive Load 230 VAC 50 Hz 12 VAC 16,7 A Transformer VA rating Fuse type 14A 250VAC 14A 30VDC 6A 250VAC 6A 30VDC 200VA 5x20mm cartridge fuse Frequency band transmitter IEC Protection Class 868 MHz Class II Inductive Load 5A 250V slow blow/time lag General specifications Controller Ambient air temperature Humidity Dimensions Weigh
Box contents 1. PL-REM-200 controller 2. Handheld transmitter (DuraLink™ version) 3. Spare battery (type A23 12V) 4. Screws (4x) & wall plugs (4x) 5.
Installation instructions • • Connect a 230VAC power source to the “220-240VAC INPUT” terminal Connect the swimming pool lights to the “Lamp 12VAC output” terminal Make sure the total load of pool lights does not exceed 200Watt Optional: The “Switch A”& “switch B” terminals can be used to control auxiliary circuits like a pool cover or garden lights.
Pairing handheld transmitter & controller The handheld transmitter is already paired in the factory and ready to use. The PL-REM-200 can pair with up to 6 handheld transmitters. In case a problem arises,the pairing process can be done manually: Manual Pairing process: Make sure the PL-REM-200 is connected to a power source. 1. Pressthe pairing button on the small circuit board, inside the controller for at least 5 seconds. --> The LED will start to blink fast 2.
Handheld transmitter functions Toggle the lamps ON/OFF Go to next color scenario Toggle Output A ON/OFF Toggle Output B ON/OFF Replacing transmitter battery • • Remove the philips head screw and open the transmitter Replace the battery, respecting the polarity Battery type: A23 12V + - Troubleshooting PROBLEM The controller doesn’t react to transmitter commands • • • The pool lights don’t work • • • SOLUTION Check the battery of the handheld transmitter The transmitter is not pairedcorrectly with
Contact details Propulsion Systemsbvba Dooren 72 1785 Merchtem, Belgium Tel +32 2 461 02 53 Fax+32 2 706 59 60 402-0019-150106 www.propulsionsystems.be info@propulsionsystems.be r t unse er is n Lebe Wass Garten Ihr Teich und Pool Profi Koigarten Müller Randenstr. 4 88605 Meßkirch www.koigarten-mueller.
