Tus neeg siv phau ntawv
EN
Virtufit Trampoline with Safety Net
12
�
�
ASSEMBLY INSTRUCTIONS
IMPORTANT
• Springs must be attached the right way around and fully inserted into the holes along the top of the
frame.
• It is easier to place one hand on the frame and pull the spring towards you.
• Make sure that (a) is attached to the D-rings of the jumping mat and (b) is attached to the trampoline
frame.
• The placement of the next spring must be on the opposite side of frame, then center adjacent, then
opposite. It must be done this way so the tension of the spring is spread equality.
• To ensure that you have started to fit the bed correctly, please count the spring holes in between
each top rail to make sure that you have the same number of spring holes in the top rails.
• Make sure that the D-rings on the bed, match the number of holes along the top rails.
• If you notice that you have skipped a hole and D-ring connection, recount, remove and adjust
accordingly.
Installing the Protective Edge:
• Lay Frame Cover (A) on outer edge, so springs are covered. It should be fitted like a shower cap. It
should be fitted like a shower cap. Please ensure it covers all metal parts.
• Tie the strap located at the under side of the Frame Cover to frame. Do not tie them to the springs.