Tus neeg siv phau ntawv
ENGLISH
EN
04
USE
Turning on and off
• Switch the device on by pressing and holding the on/off switch
on the bottom of the device for three seconds.
• The Mini Massage Gun starts in speed level 1. Press the on/off
switch once to increase the speed by one level and press again
to increase another level, etc.
• The maximum speed is level 4. In level 4, press the on/off switch
once and the speed goes back to level 1.
• Massage the desired body part at the desired speed, applying
light pressure if necessary.
• Switch off the device by pressing and holding the on/off switch
for three seconds.
To protect bones and muscles and prevent prolonged
automatically after 20 minutes of use.
Massage Head (FIG. A)
Changing the Massage Head
• Pull out and remove the massage head
• Push the new massage head into the device
INSTALLATIONTAKE OFF
The massage head does not need to be rotated after pushing
the massage head into the device. The different massage heads are
explained in FIG. A.
Indicator light
• The indicator light is green when switched on
• During charging, the signal lights flash in turn. When the four
signal lights are on at the same time, the battery is full.
Speed
The indicator lights represent the speed level the device is
currently at.
SPEED 1 SPEED 2
SPEED 3
SPEED 4
CHARGING
Fully charge the battery before first use. The charging input
cannot be switched on or used during charging to ensure safe use.
To prolong battery life, charge the device immediately when the
indicator light flashes red.
Charging
• Connect the end of the supplied original USB cable to the
charging port on the bottom of the device, and the other end of
the USB cable can be connected to a USB adapter or USB port
of a computer/laptop. The USB adapter is not included.
• When charging with a USB power supply, do not use a power
supply with an output specification higher than DC 5V.
Otherwise, the device will be damaged.
• Fully charge the device, which will take about 2 hours.
• After the device is fully charged for the first use, it can be used
for about 5 hours. The specific usage time depends on the speed
level and pressure applied.
• Disconnect the opader. The device is ready for use.