Tus neeg siv phau ntawv

Clima Flex Wall Mounted FCU (S type panel) CLIFC-W 2015-05
38
Installation description:
When it is necessary to use this controller, it needs to add a small 5-terminal group and fasten a infrared
emmiter near to the receiver in the switch board.Connecting the anode and cathode to A、B of the Terminal
Group, also connect +5V、GND、RUN of the switch board separately to the C、D、E of the 5-terminal Group.
Caution:
The connecting wire should be a little longer as to take away the switch board easily for maintenance
The connecting wire should be a little longer as to take away the controller easily for maintenance..
Wires here adopts 5-core Shield
Cable, the length should be accord
with the actual conditions .
Wire Controller
B
A
5-terminal Group
C
D
E
60
46
120
120
17
18
44
49
Holes matche with the
86X86 Wiring box
Wood Mounting
Screw (M4X20)
When installing the Wire
Controller Cover,be sure there is
a hole in the wall to avoid the Wire
Controller Back Cover being fixed
directly to the wall which is not
allowed for the Wire Joint
extrudes out of the Wire
Controller Back Cover
When installing the Wire Controller, you should
adjust the bottom of the Wire Controller Board to
the Wire Controller Back Cover which should be
fixed first, then press the other end of the Wire
Controller Board.
Wire
Controller
Bottom Cover
Wire Controller
Board
Wire Controller LCD
Wire Controller
Top Cover
Wire Controller
Back Cover
Turn a screwdriver at the concave on bottom panel
of the Wire Controller to remove the Back Cover