Tus neeg siv phau ntawv

Clima Flex Wall Mounted FCU (S type panel) CLIFC-W 2015-05

ltaneously sends the OFF. If having set TIMER ON or TIMER OFF, the wire controller will cancel these

settings before entering into OFF, close the concern indicator, and then send the OFF information.

8. Fan speed selection button (FAN SPEED)

Select any one fan speed from "AUTO", "LOW"," MED" , and "HIGH”. Each time push the button, the fan

speed will change in turn as fellow.

9. Adjust button ▲:

Set indoor temperature up. If press and hold on, it will increase at 1 degree per 0.5 second.

10. Adjust button ▼ :

Set indoor temperature down. If press and hold on, it will decrease at 1degree per 0.5 second.

11. Swing button:

Push this button for the first time when operation,it will start the swing function. Push the button for the

second time, cancel the swing function. (The function is available matched with the concerned unit)

12. Economical button:

Push the button to set the economical operation mode for air conditioner, push again then cancel the

mode. The operation mode is suitable for sleeping time.

13. Cool only/cooling and heating selec- tion button (hidden):

Use a small stick with a diameter of 1mm to push the button to switch modes.For COOLING ONLY type, it

will be no heating mode when pressing MODE. The uniform mode is COOLING and HEATING at the

factory.

14. Lock button (hidden):

Use a small stick with the diameter of 1mm to push the LOCK button to lock the current setting, push the

button again then cancel the setting.

Installation

Wiring Principle Sketch:

Installation description:

When the air conditioner needs the constant frequency wire Controller, be sure adding a Wire Joint with 5

terminal named A, B, C, D, E in indoor unit, and fixing a infraed emitter whose anode and cathode

connecting with A and B near the receiver in the Indoor Unit Switch Board, then connecting the terminal +5V,

GND, Run in the Switch Board to C, D, E respectively.

NOTE

Never turn screws too tightly, or else the cover would be dented or the Liquid Crystal breaks.

Please leave enough long cable for maintenance of the Wire Controller Board.

5-Core Shield Cable, the length

is decided by installation

Wire Joint, 5p

Infraed Pipe

Indoor Unit

RUN

GND

+5V

Indoor Unit Switch Board

Wire Controller