Tus neeg siv phau ntawv

CLIFC-W 2015-05 Clima Flex Wall Mounted FCU (S type panel)
33
state of TIMER OFF adjustment or after only set the TIMER OFF; Display ON/OFF if simultaneously set
the mode of TIMER ON and TIMER OFF.
7.
Temperature display area:
Usually display the set temperature. Press the buttons of and to set temperature, at the mode of FAN,
there is no figure display in the area.
Name and functions of buttons on the wired controller
1. Mode selection button:
It is used to select mode, push the button one time, then the operation modes will change in turn as
follows:
AUTO→ COOLING →DEHUMIDIFY →HEATING→ FAN
Remark: no heating mode if wire controller is set as the cool only.
2. Timer on button:
Push the button to set TIMER ON, each time you push the button the time moves forward by 0.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If
want to cancel the TIMER ON, then adjust the time of TIMER ON as 0.0
3. Timer off button:
Push the button to set TIMER OFF, each time you push the button the time moves forward by 0.5 hours.
When the set time is over 10 hours, each time you push the button the time moves forward by 1 hour. If
want to cancel the TIMER OFF, then adjust the time of TIMER OFF as 0.0
4. CLOCK button:
Normally display the clock set currently (display 12:00 for the first electrifying or resetting). When push the
button for 4 seconds, the hour part on the clock display flashes every 0.5 seconds, then push button
and to adjust hour; push the button CLOCK again, the minute part flashes every 0.5 seconds, then push
and button to adjust minute. When set clock or alter clock setting, must push the confirm button to
complete the setting.
5. Ok button:
The button is used at the state of CLOCK adjustment. After select the time, push the button to confirm
then exit, the current clock will display
6. Reset button (hidden):
Use a small stick with a diameter of 1mm to push the RESET button to cancel the current settings and get
into the condition of resetting.
7. ON/OFF button:
Push the button at the condition of OFF, the OPERATION lamp lights, ans the wire controller enters into
ON operation, simultaneously sends the information of operation mode set currently, temperature, fan
speed, timer etc. Push the button at the conditionof ON, the OPERATION lamp extinguishes, simu-
ON / OFF button
①
②
③
④
⑤
⑥
Adjust button ▲
Adjust button ▼
TIME R ON
TIME R OFF
TEMP
R E PL A C E L OC K
C O OL
H E AT IN G
MO DE
FAN SPEED
CLOCK
CO NFIRM
ECONOM ICAL
SW ING
Economical button
Swing button
COOL ONLY/COOL and
Heating selection button
Lock button
Timer on button
Timer off button
Clock button
confirm button
replace nutton
Mode selection button
Fan speed selection
Reset button
RESET
OK
Ok button