Phau Ntawv Qhia

37 38
6. The completely assembled base
is shown as (Fig. 9)
!
The ISOFIX connectors must be
attached and locked onto the
ISOFIX anchor points. (Fig. 9.1)
!
The load leg must be installed
correctly with green indicator.
(Fig. 9.2)
7. Please refer to rear facing mode
and recline positions mode in
section to use the child restraint.
8. To remove from the vehicle press
the ISOFIX adjuster button
(Fig. 10.1) and pull the base back
from the seat. (Fig. 10.2)
9. Then press and release the
connectors from the vehicle’s
ISOFIX. (Fig. 11)
10. Transit to prevent damage
during. Press the ISOFIX
adjuster button (Fig. 12.1) and
fold the connector completely.
(Fig. 12.2)
Recline Adjustment
Height Adjustment
for Head Support and Shoulder Harnesses
see images
13
-
14
Squeeze the recline adjustment
button (Fig. 13), to adjust the child
restraint to the proper position. The
recline angles are shown as (Fig. 14)
!
Please recheck the load leg
position after reclining.
Limit to use the most reclined
position (1
st
position) with rear
facing mode.
There are 5 recline positions for
forward facing mode. (Fig. 14)
see images
15
-
17
1. Please adjust the head support
and check if the shoulder
harnesses are at the correct
height according to
(Fig. 15)
! When used rear facing and
forward facing, the shoulder
harness height must be
even with or just above the
child’s shoulders. (Fig. 15)
11
1
2
12
1
2
10
1
2
13
14
15
9
1
2