User guide
UPDATING FIRMWARE
1. Download and extract the attached zip le. There are 2 les within the zip. The one
you will need is 2NDSHOOTER.IMG.
2. Plug in the power cord for the Second Shooter controller.
3. Plug the micro-USB to USB cable from the USB port on the computer into the
micro-USB port on the controller.
4. Once system powers up, navigate to SETTINGS.
5. In SETTINGS, nd and select FIRMWARE UPDATE.
The Controller will display FIRMWARE UPDATE READY…
6. The Controller will show up as a USB device on your computer titled 2nd Shooter.
7. Go to the location where you extracted 2NDSHOOTER.IMG.
8. Click and drag 2NDSHOOTER.IMG to the USB device titled 2nd Shooter and release.
9. The system is now updating. The Controller’s screen will detail the update process.
10. Select REBOOT to restart the controller.
MAC Users:
Once ‘Reboot’ is selected during the update rmware process, a ‘Disk Not Ejected Properly’
message appears on the Mac OS X desktop. Users may simply close this message without
issue.
11. As the system restarts, conrm the splash screen shows the latest rmware version
across the bottom.
TERM REFERENCE GUIDE
Exposure – The length of time the camera’s shutter is open when taking a photograph
Delay – Amount of time between photos
Ramp – Rate of Change of acceleration/deceleration
Visit support.kesslercrane.com for manuals, support videos, references & more
9