User guide

SETTING UP A MOVE

After powering up the system you will be presented with four options:

• PROGRAM MOVE

• MANUAL MOVE

• TURNTABLE

• SETTINGS

Settings

• Swap Controls – Inverts Controls depending on user preference

• Firmware Update – See “Updating Firmware” section

Manual Move

Select MANUAL MOVE to do a live move without programming.

1. The default speed of Manual Move mode is 50%. This selection will be blinking. If

you’d like to adjust that speed up or down you can do so using the Up or Down arrow.

Once you’ve adjusted that to the speed you like, press Enter.

2. The screen will now display RUNNING which allows you to manually move each axis

by using the directional arrows.

Turntable

Select TURNTABLE for continuous panning.

The speed can be adjusted by pressing the Up or Down arrow at any time.

Press the Left or Right arrow to start/stop panning.

Program Move

Select PROGRAM MOVE to set the 1st (begin) and 2nd (end) key frames for the move.

Be sure each axis is in the desired position before selecting SET 1ST KEY FRAME or

SET 2ND KEY FRAME.

1. Position your Slider and Pan & Tilt head to desired beginning position and press

ENTER to SET 1ST KEY FRAME.

2. Position your Slider and Pan & Tilt head to desired end position and then press

ENTER to SET 2ND KEY FRAME.