User Manual

SLIDER/DOLLY TIME LAPSE

MOTION CONTROL - SIMPLE

Before running your rst time lapse on a slider or dolly, perform the

calibration procedure to insure proper function.

1: Once in Slider/TT mode press the MENU button until you

get to the main menu

2. Select Motion Control by moving the joystick up or

down

Press the MIDDLE JOYSTICK BUTTON or ENTER to conrm.

3. To toggle Simple mode, move the Joystick down to Advanced

Press and hold the 1 Button for 5 seconds

Press the MIDDLE JOYSTICK BUTTON or ENTER to conrm.

4. Select one of the following:

Continuous or No Intervlmtr

Press the MIDDLE JOYSTICK BUTTON or ENTER to conrm.

5. Press the 1 BUTTON to select 1:Distance

Camera

Motion Control < v

Advanced ^

Simple <

Continuous

No Intervlmtr

6. Move the joystick up and down to change the Y:Distance

amount. Distance is displayed in both inches and centimeters.

7. Once you have your desired distance adjusted press MIDDLE

JOYSTICK BUTTON or ENTER to save.

This will bring up the next menu for setting time.

Note:

You can move the joystick LEFT/RIGHT to navigate through sub-menus

8. Move the joystick up and down to select Y:Time.

Time can be adjusted in decimal minutes (M),

decimal hours (H), or decimal days (D).

9. Once you have your desired time set press the MIDDLE

JOYSTICK BUTTON or ENTER

10. Press ENTER again

1:Distance 3:Cal

2:Time ENTER:Run

Y:Distance

2.8IN 7.1CM

Y:Time 6M 47S

Pictures 280

1:Distance 3:Cal

2:Time ENTER:Run