Owner manual
SLIDER/DOLLY
MOTION CONTROL - ADVANCED
In Advanced mode, you can program complex motor movements
on a slider/dolly/shuttle pod. If you need to create a complex time
lapse move, we recommend using the optional SmartLapse™ mode
as it is easier to program.
1: Once in Slider/TT mode press the MENU button until you
get to the main menu
2. Select Motion Control
Press the MIDDLE JOYSTICK BUTTON or ENTER to conrm.
3. Select Advanced by moving the joystick down
Press the MIDDLE JOYSTICK BUTTON or ENTER to conrm.
4. Move the joystick up or down to select one of the
following: ShootMoveShoot, Continuous, Stop
Motion, or No Intervlmtr(Intervalometer)
Press the MIDDLE JOYSTICK BUTTON or ENTER to conrm.
Advanced < ^
ShootMoveShoot
Continuous v
Stop Motion ^
No Intervlmtr
Advanced < ^
Note:
See page 17 for details on dierent shooting modes
5. Press the 1 button to select 1:SLIDER or the 2 button to
select 2:AXIS2
Quick Tip:
Move the joystick LEFT/RIGHT (X-Axis) to scroll through the sub-menus
for 1:SLIDER & 2:AXIS2
6. The 9 Sub-Menus are as follows:
This setting tells the motor how long to remain on. Stepper motors
have two states. On and o. This setting determines how long the
motor is on for each step. The default setting is a good starting point for
time lapse work.
Note:
For more information on how a stepper motor works and how these
values eect movement, see the Stepper Motors Demystied section of
this manual.
The default is 0.05 S (seconds). We recommend leaving this at the
default for starting out.
Press the MIDDLE JOYSTICK BUTTON or ENTER to accept the setting.
SLIDER Motor ON
0.05 S
SLIDER Motor OFF
0.05 S
1:SLIDER 2:AXIS2
ENTER:Run
20