User manual

YKS-01-BA-e-1010 5
5 Preparing your printer for operation
Remove the cover from the paper
compartment
Set the micro switches
The micro switches are used to set the operating mode for the printer.
1200 2400 4800 9600
SW1
ON OFF ON OFF
SW2
ON ON OFF OFF
SW3
OFF
ON
OFF
ON
SW4
OFF
OFF
ON
ON
FORMAT
8 bits – no parity
7 bits – odd parity
7 bits – even parity
7 bits – ignore parity
SW5
ON Summer time
OFF Winter time
SW6
ON Statistics ON
OFF Statistics OFF
Language
SW7
SW8
POL.
ON
ON
GER.
OFF
ON
ENG.
ON
OFF
FRA.
OFF
OFF
Changes to the settings for the micro switches must be made with the power
supply turned off.
The changes are taken over when started-up again.
Connecting the cables:
There are two interfaces at the back wall of the housing:
Terminal printer cable
Terminal power supply unit
Always use KERN accessories and weighing balances when working with your
printer. Disconnect the printer from the mains voltage before connecting the
cable to the printer.