User manual

6 YKB-01N-e-1122
6. Operating elements
After the power supply unit has been connected to the printer and the mains, and after
the
ON/OFF switch of the printer has been switched to “ON” position, the
red indicator for the power supply will light up.
This indicator also signals that the printer is ready for operation.
7. Start-up
⇒ On start-up press the FEED key; printer carries out self-test
and parameters will be printed.
Red LED is lit up, printer is ready for operation.
⇒ Press FEED key: Turn on/off date and time
⇒ Press and hold FEED: Paper will be transported
8. Setting time and date
In order to get access to the date/time mode, switch on the printer and keep the FEED
button pressed. The printer carries out a self-test, the parameters are printed.
The following note is printed at the end of the self-test:
“To set date and time push a long time the button or a short to exit.”
After this note press and hold the FEED button. The note “Set
time, push a short to change value a long time to valid.” is
printed.
Time and date are printed 00:45 21/01/11
(Example)
Setting time:
Press the FED button, an arrow is printed on top of the first digit
of the hour display; the date display is no longer printed.
V
10:45
(Example)
Press the FEED button several times until the required hour is
shown.
V
20:45
(Example)
Press and hold the FEED button in order to select the second
digit. The arrow is shown on top of the second digit.
V
20:45
(Example)
Press the FEED button several times until the required hour is
printed.
V
23:45
(Example)
Proceed as described above in order to change the digit of the minute display.
After having changed the time, the date/time mode can be left either by pressing the
button for a short period of time or change over to set the date by pressing the button
for a long period of time: