User manual

21 WTB-N-BA-e-1220
8.4 Weighing with tolerance range
You can set an upper or lower limit when weighing with tolerance range and thus
ensure that the weighed load remains exactly within the set tolerance limits.
Settings:
(example)
(example)
 In weighing mode press for about 3 seconds, the
display for entering the upper limit appears. The left digit
blinks. A triangle appears above the "+" symbol.
Moreover, the background of the screen turns red.
 Enter upper limit value, the active position blinks.
Mit Correct the numerical value by , change the
decimal using . If the last digit is entered, confirm input
by , the upper limit value is hereby saved.
The display changes to the prompt for entering the lower limit
value.
The colour of the display then changes to orange.
 Now enter the lower limit value as described above and
confirm input using . The lower limit value is thus
entered. The balance changes into weighing mode.
Audio signal:
The acoustic signal depends on the settings in menu block „F9 BEP“.
Options:
BEP 0
Acoustic signal turned off
BEP 1
An acoustic signal sounds when load is within tolerance limits
BEP 2
An acoustic signal sounds when load is beyond tolerance limits