User manual

PFB-BA-e-1322 15
6.7.2 Adjustment procedure (models PFB-M):
Observe stable environmental conditions.
A warming up time (see chapter 1; Technical Data) is required for stabilization.
Ensure that there are no objects on the weighing plate.
Balance display
Operation
 Start balance by pressing During the
selftest press .
„F1 Unt“ is displayed.
 Press repeatedly until „tECH“ is displayed
 Press adjustment switch on the lower side of the balance!
 Press , „Pin“ is displayed
 Enter password:
Press , , subsequently.
„P1 Lin“ is displayed
 Press , „P2 CAL“ will be displayed

 Press , „UnLoAd“ followed by „LoAd“ is
displayed.
 Put the necessary adjustment weight (see
chap.1; Technical Data) on the centre of the
weighing plate.
Adjustment will be carried out automatically after dead
stop control.
 Wait for stability display