User manual

18 PFB-BA-e-1322
 Put on weight 1 (see table chap. 6.8.1)
 Wait for the stability display and the signal sound
 „LoAd 2“ appears
 Remove weight 1 and put on the weight 2
 After the stability display and the signal sound
„LoAd 3“ appears; remove weight 2 and put on
weight 3
 After the stability display and the signal sound
„LoAd 4“ appears; remove weight 3 and put on
weight 4
 After having placed weight 4, „LoAd 0“ appears
again
 Remove weight 4, „LoAd 4“ appears anew
 Place weight 4 again
 Wait for the stability display and the signal
sound, „LoAd 3“ will be displayed
 Remove weight 4 and place weight 3
 Wait for the stability display and the signal
sound, „LoAd 2“ will be displayed
 Remove weight 3 and place weight 2
 Wait for the stability display and the signal
sound, „LoAd 1“ will be displayed
 Remove weight 2 and place weight 1
 Wait for the stability display and the signal sound
 „LoAd 0“ will be displayed
 Remove weight 1
 After the stability display and the signal sound
the balance carries out a selftest and changes
into the weighing mode. Now the linearization is
concluded successfully.