User manual

PES/PEJ-BA-e-1316
69
12.5. Evaluation with difference values
12.5.1. Entering 2 limits by weighing
Important information!
Always begin by entering the lower limit value, followed by the upper limit value.
Enter.
Operation
Display
1. Tolerance weighing function
[ ] or [ ] (see chapter
7).
2. Actuate required parameter selection
or
until
[ ] or [ ] appears;
more settings of your choice (see chap.
12.3) are carried out in the same way
Parameter selection for 2 limiting points:
Parameter selection for difference value:
3. Leave function menu
g
The balance is now in tolerance weigh-
ing mode; the tolerance marker (
)
appears