User manual

PES/PEJ-BA-e-1316
60
12.4. Evaluation of absolute values
12.4.1. Entering 2 limits by weighing
Important information!
Always begin by entering the lower limit value, followed by the upper limit value.
Enter.
Operation
Display
1. Activate tolerance weighing function
[ ] or [ ] (see chap. 7).
2. Actuate required parameter selection
or
until
[ ] or [ ] is displayed;
more settings of your choice (see chap.
12.3) are carried out in an analogue
manner
Parameter selection for 2 limiting points:
Parameter selection for absolute value:
3. Leave function menu
g
The balance is now in tolerance weigh-
ing mode; the tolerance marker (
)
appears