User manual

PES/PEJ-BA-e-1316

6. Unpacking, Setup and Commissioning

6.1. Installation Site, Location of Use

The balances are designed in a way that reliable weighing results are achieved in

common conditions of use.

You will work accurately and fast, if you select the right location for your balance.

Therefore, observe the following for the installation site:

Place the balance on a firm, level surface;

Avoid extreme heat as well as temperature fluctuation caused by instal-

ling next to a radiator or in the direct sunlight;

Protect the balance against direct draughts due to open windows and

doors;

Avoid jarring during weighing;

Protect the balance against high humidity, vapours and dust;

Do not expose the device to extreme dampness for longer periods of

time. Non-permitted condensation (condensation of air humidity on the

appliance) may occur if a cold appliance is taken to a considerably war-

mer environment. In this case, acclimatize the disconnected appliance

for ca. 2 hours at room temperature.

Avoid static charging of the material to be weighed, weighing container

and windshield.

If electro-magnetic fields or static charge occur, or if the power supply is unstable

major deviations on the display (incorrect weighing results) are possible. In that case,

the location must be changed.

6.2. Unpacking

Carefully remove the balance from the packaging, remove plastic cover and setup

balance at the intended workstation.