User manual
PES/PEJ-BA-e-1316 
11 
3.  Basic Information (General) 
3.1.  Proper use 
The balance you purchased is intended to determine the weighing value of material 
to be weighed. It  is intended to be used as a “non-automatic“ balance, i.e. the ma-
terial to be weighed is manually and carefully placed in the centre of the weighing 
plate. As soon as a stable weighing value is reached the weighing value can be read. 
3.2.  Improper Use 
Do not use balance for dynamic weighings. In the event that small quantities are re-
moved or added to the material to be weighed, incorrect weighing results can be dis-
played due to the “stability compensation“ in the balance. (Example: Slowly draining 
fluids from a container on the balance.)  
Do not leave permanent load on the weighing plate. This may damage the measur-
ing system. Impacts and overloading exceeding the stated maximum load (max) of 
the balance, minus a possibly existing tare load, must be strictly avoided. This could 
cause damage to the balance. 
Never operate balance in explosive environment. The serial version is not explosion 
protected. The structure of the balance may not be modified. This may lead to incor-
rect weighing results, safety-related faults and destruction of the balance. 
The balance may only be used according to the described conditions. Other areas of 
use must be released by KERN in writing. 
The appliance may only be opened by trained service technicians according to 
KERN standards. 
Before opening, disconnect appliance from power supply! 
Warranty claims will be voided when appliance is opened. 
The PES/PEJ weighing system may not be used in explosive areas or areas 
with explosive substances. 
3.3.  Warranty 
Warranty claims shall be voided in case    
  our conditions in the operation manual are ignored 
  the appliance is used outside the described uses 
  when the appliance is modified or opened 
  mechanical damage and damage caused by media, liquids 
  natural wear and tear 
  the appliance is improperly set up or incorrectly electrically connected 
  the measuring system is overloaded 










