User manual

12 PBS-A03/A04-BA-e-1213
4.3 Measurement „Density solid material“
1. Repeatedly press
UNIT
until the balance
is in density determination mode for solids.
May be that „dSP pL“ can be displayed, but
in that step this isn’t any error message
and can be ignored.

2. Press
TARE /
(no change of the display).
3. Place sample in the upper sample dish.
4. Wait for stability display, then press
MENU
CAL
.
May be that „dSP pL“ can be displayed, but
in that step this isn’t any error message
and can be ignored.
5. Place sample in the lower sample dish.
6. The density of the sample is shown.
To start the next measurement press
MENU
CAL
, before the current sample is removed
from the lower sample dish. For the new measurement start at step 2.
When using an other measuring liquid, start at the entry „Density measuring liquid“,
see chapter 4.2.
Using
UNIT
the balance returns into the weighing mode.