User manual

EW/EG-N/EWB-e-1226

From now on the applied weight is

shown as a percentage.

Use the key to return to the desired

weighing mode.

Information:

 If the “o-Err “ error message appears:

- the reference weight is outside the weighing range (see chap. 1 ”Tech-

nical Data“).

- the set key was operated during step 2 when the weight had been ap-

plied.

 The 100% reference is preserved until the balance is disconnected from the

mains.

6.2.4 Weighing using a tolerance range

(excl. model KERN EW120-4NM)

This balance can be used as a measuring and sorting balance, whereby the respec-

tive lower and upper tolerance limits are programmable.

Limit values can be entered in the following operating modes:

 Weighing

 Unit counting

 Percent weighing

0 I I I F

85.37 %

Pcs