User manual

EMB-V-BA-e-1321
31
+ Mode to call up density determination of liquids.
1. Turn on the scale with , "0.000" is displayed.
2. If the scale does not display, "0.000", press
3. Call up the density determination mode of liquids by pressing .

"Liquid" is displayed briefly, followed by the actual entered density of the sinker.
Initial entry or if it is necessary to change them describes will be described later.
While using the same sinker, the entered density stays stored. Skip the following
steps for additional measurements and start by determining the density of the
liquid (step 7).
+ Enter the density of the sinker.
4. Press and the last digit flashes.
5. Use to increase the numeric value of the flashing cipher.
Use to move the number selection to the right, the respective active
position flashes.