User manual

EW/EG-N/EWB-e-1226
42
6.2.4.2 Entering the limit values by weighing
Important information !
Always begin by entering the lower limit value, followed by the upper limit
value.
Operation
Display
1. Use the key to switch the balance
on.
Set to tolerance weighing:
Press the key until [L. SEt] appears
and then release.
2. The tolerance mark
will flash [ - ].
The lower limit value can be set.
Place a sample for the lower (i.e.
smaller) limit value on the weighing
plate:
Store using the key. The stored lower
weight value is displayed briefly.
Entry is now completed if 1 tolerance
mark was selected in the basic setting
(see chap. 7.2.1).
ο 0 I I I F
0.000 g
L. SEt
M 0.000 g
M 93.835 g