KERN & Sohn GmbH Ziegelei 1 D-72336 Balingen E-Mail: info@kern-sohn.com Tel: +49-[0]7433- 9933-0 Fax: +49-[0]7433-9933-149 Internet: www.kern-sohn.com Operating Instructions Hanging Balance KERN CH Version 2.
GB 1 Operating Instructions Hanging Balance Technical Data CH15K20 KERN CH50K50 CH50K100 CH50K500 Readout 20 g 50g 100g 500g Weighing range 15 kg 50kg 50kg 50kg 2 Fundamental information (general) 2.1 Intended use The balance you have acquired serves to determine the weighing value of the material to be weighed. It is intended to be used as a “non-automatic“ balance, i.e. the material to be weighed is manually and carefully attached at the balance.
4 Transport and storage 4.1 Acceptance check Please check the packaging immediately upon delivery and the device during unpacking for any visible signs of external damage. 4.2 Packaging Please retain all parts of the original packaging in case it should be necessary to return items at any time. Only the original packaging should be used for return consignments. Before despatch, disconnect all attached cables and loose/movable parts. Apply any intended transport security devices. Secure all parts, e.g.
7 Operation Instruction 7.1 Weighing This function is suitable for unsteady weighing procedures. A mean value is derived from 16 weighing values. The animal weighing function is set in the following way: • The balance is switched on by pressing the "ON/OFF/TARE" key. • • • The balance display shows "0.00“. • • Hang on the weighing object carefully. • • • • If the weighing object is heavier than the weighing range the display indicates "E“ (=Overload). Be sure to prevent overloading (chap. 2.
8 Maintenance, upkeep, disposal 8.1 Cleaning Only use a cloth dampened with mild suds and not aggressive cleaning agents (solvents or similar). Please ensure that fluids are not able to get into the device and rub off using a clean, soft cloth. Loose sample residue/powder can be removed carefully using a brush or hand vacuum cleaner. 8.2 Maintenance, upkeep The operating company shall ensure that load-bearing components are checked by a competent person at maximum intervals of one year.
