User manual

5.4 Measurement „Density liquid“
1. Suspend the glass sinker.
If no glass sinker is suspended, may be „oL“ will be displayed,
however in this step it is no error message and can be ignored.
2. Repeatedly press the UNIT/ button until the balance is in
density determination mode for liquids "d". If the weight is
measured in air, additionally a „g“ will be displayed.
3. Press the TARE/ button.
4. When standstill control is complete, press the CAL/MENU
button
5. Remove the glass sinker.
6. Put the container with the sample liquid on the platform.
7. Suspend again the glass sinker and immerse it into the liquid
completely and without bubbles.
8. When standstill control is complete, the density of the sample
liquid will be shown in the display.
Remove glass sinker and container.
If no glass sinker is suspended, may be „oL“ will be displayed,
however in this step it is no error message and can be ignored.
For further measurements
Ö Clean and dry container and sinker carefully
Ö Suspend again the glass sinker
Ö Press the CAL/MENU button
Ö Start with step 3
ABS-A02-BA-e-1010 15