User manual

572/573/KB/DS/FKB/FCB/KBJ-BA-e-1370
26
6.8 Adjusting (go to 7.2.6)
Using a precision weight, the accuracy of the balance can be checked at any time and
adjusted.
Warning:
With verified balances, this precision adjustment is not possible
Adjustment procedure:
Check that the surrounding conditions are stable.
A short warm-up time of about 15 minutes is recommended for stabilisation.
6.8.1 Adjusting for verification (KERN 573; FKB-M; KB-NM; FCB-M; DS-M)
General Information:
Prior to the procedure of verification the balance has to be adjusted.
Remark: The adjusting is only possible when not being blocked by the adjusting switch.
The switch for this step is located at the bottom of the housing between the two
turning feet.
At the model FKB the cover plate from the housing bottom must be removed.
Switch to the right
Adjusting function is released.
This setting has to be selected before starting the
adjusting.
Executing the adjusting according to chapter 7.2
“Operation“.
After the adjusting has been completed success-
fully it is necessary to turn the adjusting switch to
the left for blocking.
Switch to the left
Adjusting function is blocked.
After the adjusting has been completed success-
fully the adjusting has to be blocked by switching to
the left.
The balance is now prepared for the procedure of
verification.
After the verification the adjusting switch has to be
secured by a verification mark against access.