User guide

Sauter GmbH
Ziegelei 1
D-72336 Balingen
E-Mail: [e-mail]
Tel: +49-[0]7433- 9933-199
Fax: +49-[0]7433-9933-149
Internet: www.sauter.eu
Instruction Manual
HMR
HMR-BA-e-1212 6
6.5 Test Set
At the main display interface, 【 MENU 】 key has to be
pressed to enter the main menu.
【 ETR 】 has to be pressed to enter Test Set Menu. The
symbol ↓ at the left side of underside menu indicates that
the menu has not ended. 【 】 key has to be pressed to
glance downward continuously.
The symbol ↑ at the left side of the upside menu indicates
that the menu has not ended. 【 】 has to be pressed to
glance upward continuously.
The 【 】 or 【 】 key has to be pressed to move the
cursor to the desired line to set and 【 ETR 】 has to be
pressed to confirm.
Note: 1. When 【 Hard/бb 】 is switched to бb, hardness
scale cannot be selected. The cursor will skip over
【 Hardness Scale 】 while it is moved.
2. Only D type of impact device has got the function of
бb measurement. So the cursor cannot be moved to
【 Hard/бb 】 while another impact device is used.
6.5.1 Impact Direction Setting
The key or the key has to be pressed to
move the cursor to the desired impact direction.
【 ETR 】 has to be pressed to confirm.
【 ESC 】 has to be pressed to cancel.
6.5.2 Average Times Setting
Average times can be modified within the range of 1 to 32.
The 【 0 】 ~ 【 9 】 key has to be pressed to input the
number value. The cursor will shift right around
automatically when inputting the number.
【 ETR 】 has to be pressed to confirm.
【 ESC 】 has to be pressed to cancel.
6.5.3 Material Setting
If 【 Hard/бb 】 is preset to hardness, following material will
be displayed: Steel and Cast Steel, Cold Work Tool Steel,
Stainless Steel, Grey Cast Iron, Nodular Cast Iron, Cast
Aluminium Alloys, Copper-Zinc Alloys, Copper-Aluminium
Alloys, Wrought Copper and Wrought Steel.
The 【 】 or 【 】 key has to be pressed to move the
cursor to the material desired to preset.
【 ETR 】 has to be pressed to confirm.
【 ESC 】 has to be pressed to cancel.
Note: 1. Presetting the hardness scale, HL is
automatically recovered after material presetting has
been changed.
2. Please select material first and then select hardness
scale.
If 【 Hard/бb 】 is preset to бb, following material will be
displayed: Mild Steel, High-Carbon Steel, Cr Steel, Cr-V
Main display interface
Test Set
Print Set
Memory Manager
System Set
Software Info
Impact Direc.
Average
Material
Hardness Scale
Tolerance Limit
Hard/бb：Hard
(Print Set is NOT
available）
View From No.1
View From End
View From No.
Transfer
Delete by No.
Delete All
Auto Save：
Auto Print：
（N/A）
Auto Delete：
Auto Trans.：
Key Sound：
Warn. Sound：
LCD Brightness
Time Date Set