Owner's manual

8. Linearization
8.1 Linearization
Linearity shows the greatest deviation of a weight display on the scale to the value of
the respective test weight according to plus and minus over the entire weighing
range.
If linearity deviation is discovered during a monitoring of test resources, you can
improve this by means of linearization.
• Carrying out linearization is restricted to specialist staff possessing well
acquainted with the workings of balance.
• The test weights to be used must be adapted to the balance’s
specifications; see chapter 2.9 “Testing instruments control”.
• Observe stable environmental conditions. Stabilisation requires a certain
warm-up time.
• After successful linearization you will have to carry out calibration; see
chapter 2.9 “Testing instruments control”
34 HFA-BA-e-1511