Sauter GmbH Ziegelei 1 D-72336 Balingen E-Mail: info@sauter.eu Tel: +49-[0]7433- 9933-199 Fax: +49-[0]7433-9933-149 Internet: www.sauter.eu Instruction Manual Digital Shore Hardness Tester SAUTER HD Version 2.
GB SAUTER HD Version 2.1 01/2015 Instruction Manual Digital Shore Hardness Tester Thank you for buying a digital SAUTER Shore hardness tester. We hope you are pleased with your high quality instrument and with its big functional range. If you have any queries, wishes or helpful suggestions, do not hesitate to call our service number. Summary: 1 Features .......................................................................................................... 3 2 Specifications ........................
This Shore Hardness Tester is small in size, light in weight, easy to carry, it is convenient to use and operate. It`s ruggedness will allow many years of use if proper operating techniques are followed. Please read the following instructions carefully and always keep this manual within easy reach. 1 Features * Designed to determine the indentation hardness of materials ranging from cellular products to rigid plastics. Each durometer type is made to a specific scale ( i.e.
Standard Accessories: * Main unit * Test block * Carrying case * Operation manual Optional Accessories: * RS-232 data output 3 Front Panel Descriptions 3-1 3-2 3-3 3-4 3-5 3-6 3-7 3-8 3-9 3-10 3-11 3-12 3-13 4 Display Number of measurements in the state of Average Value Indicator of Average Value RS 232 Interface max.
4 Measuring Procedure 4.1 The Specimen should allow measurement to be taken at least 12 mm from any edge. Specimen surface should be flat and parallel to allow the presser face to contact to the specimen over an area which has a minimum radius of 6mm from the durometer probe.
4.7.5 To release from average measurement, just press the “N/AVE” till “N” disappears. 5 Calibration Check To check whether the tester is accurate, just insert the indenter into the hole of the calibrated test block. Apply enough force to make firm contact between the top surface of the test block and the presser foot. The reading should agree with the value stamped on the test block. If not, just carry out Zero calibration and High end calibration. 5.
8 Declaration of Conformity Sauter GmbH Ziegelei 1 D-72336 Balingen E-Mail: info@sauter.eu Ziegelei 1 D-72336 Balingen E-Mail: info@sauter.
