User`s guide

3.3 Setting hardware phone provisioning

New hardware phones, which Kerio Operator can conﬁgure automatically, were bought for the

new phone network. Kerio Operator in its current version supports the following phones:

• Cisco 7940 and 7960 with the SIP ﬁrmware in version 3 and higher,

• Linksys SPA942, SPA962, SPA922, SPA901, PAP2T with ﬁrmware in version 5 and

higher.

• Snom 300, 360, 820, m3 and MeetingPoint.

Apart from the settings in the administration interface, hardware phone provisioning also

requires a running DHCP server in the network. DHCP server must support parameter 66

(TFTP server address)

1. In parameter 66, set the name or IP address of Kerio Operator.

2. Go to Kerio Operator administration interface to section Conﬁguration → Provisioned

Phones.

3. Check whether the Enable provisioning option is enabled.

4. Enter the number (extension) which will start automatic phones provisioning. If the ﬁrst

number is set to 10, the next one will be 11 and so on. If a number is already in use (if the

extension was created manually), it will be skipped.

5. Enter a password which hardware phones employing provisioning will use to authenticate.

Detailed information on the whole provisioning process can be found in manual

Kerio Operator, Administrator’s Guide.

3.4 Dial out setting

For outgoing calls and calls to the company branch, it is necessary to set a call interface.

Connection to branch oﬃce

To set a connection with the branch oﬃce, go to section Conﬁguration → Call Routing:

1. Click on Add a SIP interface. This opens the conﬁguration wizard.

2. In the ﬁrst step, enter the name for the interface (for example branch). The name cannot

contain spaces, national and special characters and must be unique.

3. Select the Link to another PBX option and click on Next.

DHCP server integrated in Kerio Control supports parameter 66.