Manual

ManualsBrandsKeri Systems ManualsEquipmentTime and Attendance

Time and Attendance

2305 Bering Drive 01943-001 Rev. B

San Jose, CA 95131 USA

(800) 260-5265 (408) 435-8400 FAX (408) 577-1792

Web: www.kerisys.com E-mail: sales@kerisys.com Page 1 of 4

PXL-500 / PXL-510Application Note

This application note provides basic information for the installation and use of the Time and

Attendance Terminal. The Time and Attendance Terminal consists of a standard PXL-500/SB-593

encased in a secure enclosure. The Time and Attendance Terminal is available in five different

configurations:

• Proximity controller with no reader connected

• Wiegand controller with no reader connected

• Proximity controller with an MS-3000 installed

• Wiegand controller with a P-300 reader installed

• Wiegand controller with a P-300H reader installed

Figure 1: The Time and Attendance Terminal

Summary of content (4 pages)

PAGE 1
Time and Attendance • • • • • Proximity controller with no reader connected Wiegand controller with no reader connected Proximity controller with an MS-3000 installed Wiegand controller with a P-300 reader installed Wiegand controller with a P-300H reader installed Application Note This application note provides basic information for the installation and use of the Time and Attendance Terminal. The Time and Attendance Terminal consists of a standard PXL-500/SB-593 encased in a secure enclosure.
PAGE 2
PXL-500 / PXL-510 Application Note Time and Attendance 1.0 Wiring The wiring of a Time and Attendance Terminal is exactly the same as for any PXL-500. All wiring diagrams and instructions may be found in the PXL-500/PXL-510 Quick Start Guide (P/N 01918001) and SB-593 Satellite Board Quick Start Guide (P/N 01925-001). Time and Attendance Terminals ordered with a reader come with the reader pre-wired. 2.0 Setup in Doors The Time and Attendance Terminal must be configured in Doors.
PAGE 3
Time and Attendance Application Note Figure 1-1: Door Type Field 2. To enable Time and Attendance Terminal control, click in the box beside Time and Attendance Terminal ON. A check mark appears in the check box and the “option changed” window appears (see Figure 1-2). 3. Click on the button. A “Saved Configuration” window flashes on the screen and the Time and Attendance Terminal control feature is enabled.
PAGE 4
Application Note Time and Attendance 2.2 Assign a Door Type After the Time and Attendance Terminal control option has been enabled, the Time and Attendance Terminal door type must be assigned to a specific door. 1. To assign a door type, click on the Setup  System pull-down menu or click on the bar button. Then click on the Doors tab (see Figure 2). tool PXL-500 / PXL-510 Figure 2: Setup System - Select Door Type 2.