Manual

Technical Reference Manual – PXL-250 and SB-293 Keri Systems, Inc.
Page 72 P/N: 01836-004 Revision 5.5
10.1 Terminal Block Connections
Follow these instructions as you make your wiring connections. Select the wire to be
installed. Strip away 1/4 inch of insulation from the wire, place the wire into the
appropriate slot on the terminal block, and tighten the corresponding screw on the top
of the terminal block (see Figure 10-2). Make a firm connection, but be careful not to
over tighten the screw.
Figure 10-2: Installing Wiring and Removing a Terminal Block
Please note that all of the terminal blocks slide off the SB-293 Satellite Board should it
become necessary to disconnect any installed cables. Firmly grasp the connector and
pull it away from the controller's printed circuit board (see Figure 10-2).