Installation Guide

NXT-WI Wiegand-Only Reader Interface Module
Installation Guide
Page 3 of 3 P/N: 02509-001 Rev. B
3.1 Verifying RIM Configuration
The corresponding reader type and line control mode LEDs are illuminated during operation. Refer to
the Drawing on page 1 for LED locations, and the Table on page 2 for LED definitions to confirm
your configuration settings.
4.0 Contact Keri Systems
end of document
Table 2: Reader Interface Module LED Guide
LED Indicator
D1 single wire LED control – red, green, amber, off
D2 dual wire LED control – red, green, amber, off
D5 Wiegand Reader enabled
LED slowly flashes
D8 RS-485 Communication
D10 lit when set for 12 VDC reader power
Keri USA Keri UK, Ireland, Europe
2305 Bering Drive
San Jose, CA 95131
Unit 17
Park Farm Industrial Estate
Ermine Street
Buntingford
Herts SG9 9AZ UK
Telephone: [phone]
[phone]
Telephone: [phone]
Fax: [phone] Fax:+ 44 (0) 1763 274 106
Web: www.kerisys.com Web:www.kerisystems.co.uk
E-mail: [e-mail]
[e-mail]
E-mail:[e-mail]
[e-mail]