Owner manual

Figure 49: Operate Hardware

Doors NetXtreme

Reference Manual Keri Systems, Inc.

Page 52 01945-100 Rev. 4.0

17.0 Operate Hardware

The Operate Hardware commands allow an operator to manually override programmed door controls.

1. Select to view the available output points (doors, gates, elevators, and/or general outputs) as icons

or as a list.

2. Select the type of output point to view (doors, gates, elevators, or general outputs).

3. Select the group or site to be viewed.

4. Select the specific individual output points or click on the “Select All” or “Deselect All” buttons.

5. To lock (doors, gates, or elevators) or deactivate (general outputs) click on the “Lock or

Deactivate” button. To unlock (doors, gates, or elevators) or activate (general outputs) click on the

“Unlock or Activate” button.

6. To perform a timed Unlock/Activation, select from the drop-down menu the amount of time for the

unlock/activation (choices are shown in seconds). Once the time has been selected, click on the

“Timed Unlock or Timed Activate” button.

7. All performed events will appear in this window.