Owner manual

Figure 32: Create New Trigger Sequence

Keri Systems, Inc. Doors Ne

tXtreme

Reference Manual

01945-100 Rev. 4.0 Page 35

9.3 Create New Trigger (I/O) Action Sequence

Setup > System > Program System (tab).

1. Click on the to reveal all trigger sources, action sequences, and action sources.

NOTE: If an expected

trigger source

is not listed, return to “Assign Inputs Property Set” on page 32

and verify the expected input has been assig

ned a property set and the changes have been applied.

2. Click on the “Add New Sequence” button.

3. A new section will appear at the

bottom of the action sequence listing.

4. Name the action sequence something that will be easily recognizable throughout the system and in

reports.

5. From the list of Trigger Sources (inputs) “drag and drop” the desired source to the Trigger column

in the new sequence.

NOTE: To “drag and drop” a trigger source or action sequence, press and hold down the mouse button

on t

he item

to be placed in the sequence and while continuing to press the mouse button down, move the

mouse until the item is over the box it is to be placed in. Insert the item into the box by releasing the

mouse button (see Figure 33 on page 36).