Owner manual

Figure 29: Assign Inputs Property Set
Doors NetXtreme
TM
Reference Manual Keri Systems, Inc.
Page 32 01945-100 Rev. 4.0
9.2.2 Assign Inputs Property Set
Click on Setup > System > Configure Controllers > Inputs (tab).
1. Click on the to reveal all doors on the controller.
2. Verify the Inputs tab has been selected to insure that all inputs in the system are visible.
3. To change the property set of an input, use the drop-down menu and select from the input property
sets designed earlier. Inputs that are in use by the system and unable to be changed are shown in
grey with “In Use By Door” shown.
4. Click on the “Apply Changes” button to save the configuration, or click on the “Undo Changes”
button to clear all changes made.