Owner manual

Figure 13: Setup Geographical Timezone

Doors NetXtreme

Reference Manual Keri Systems, Inc.

Page 16 01945-100 Rev. 4.0

4.3 Setup Geographical Timezones

Click Setup > System > Properties (tab) > Controller (tab).

1. Click “Add New” or “Duplicate.”

2. Enter Prop

erty Set Name (this is the name that will be used to select this geographical timezone).

3. Select from the drop-down menu the Geographical Timezone.

4. Select from the Daylight Saving Time Schedule in place (if any).

5. Select Auto Monitor Mode: “Y” (checked-default) or “N” (unchecked). “Y” means that events will

be automatically collected from controllers.

6. Click to save the timezone or to clear it without saving.

7. To delete a Geographical Timezone Property Set, click on the row to be deleted and click

, followed by .

NOTE: At this time it is possible to delete settings that are currently in use elsewhere in the software.

Doi

ng this

will cause the

program to not function properly. It is recommended that instead of deleting

any settings, change the name to “UNUSED.” This will be changed

in subsequent versions to not allow

deletions of functions that are in use elsewhere in the software.