Users Manual

Administering the BioPointe
33
4.4.4 Enrolling a User with Card Only
The following steps describe how to enroll a user with card only access.
Steps LED and Buzzer Status
Press , , .
The LEDs will light up as shown in 1. The sensor
will also light up, waiting for a master fingerprint
to be verified.
Place the master finger on the sensor to
verify.
a) If the finger is successfully verified as a
master, the 1
st
LED will blink green briefly as
shown in 2(a). Proceed to step 3.
b) If the finger is not successfully verified as a
master, the 1
st
LED will blink red briefly.
Operation will cease and return to normal mode.
When the 2
nd
LED starts to blink slowly
in red,
Flash your card above the fingerprint
sensor.
a) If the card ID is accepted, the 1
st
LED will
blink green briefly as shown in 3(a). Operation is
completed and will return to normal mode.
b) If the card ID is not accepted, the 1st LED will
blink green briefly as shown in 3(b). Operation
will cease and return to normal mode.
1
1
AMBER RED
2
2a
GREEN
AMBER
RED GREEN
2b
RED
AMBER
3
Master verification fails
GREEN
AMBER
3a
RED
AMBER
3b
Card ID not accepted
3