Information

Volksbank Raiffeisenbank Nordoberpfalz Sitz: 92676 Eschenbach KERAFOL Verwaltungs-GmbH | Sitz: 92676 Eschenbach
IBAN: DE27 7539 0000 0001 0410 45 Reg. Gericht Weiden: HRA 2846 Reg. Gericht Weiden: HRB 5098
UST-ID: DE815771797 Geschäftsführer: Franz Koppe, Isabell Koppe, Sabine Koppe
Storage suitability:
At least 12 month in the original packaging under frost free standard conditions: [RT // + 5°C – + 35 °C/ rel. humidity 30 –
70%]. Direct sun exposure or storage near radiators must absolutely be avoided. Opened packagings must be stored cool
and protected and should be used as soon as possible.
The thermal grease KP12 show a migration of the fillers due to their low viscosity. After remixing, see pretreatment,
(possible for Hobbock and small cans) the thermal grease is useable again.
Table 1: storage suitability of diffrent bunches
bunch
room temperature
+ 5 °C bis + 35 °C
rel.humidity 30 – 70%
rolled
room temperature
+ 5 °C bis + 35 °C
rel.humidity 30 – 70%
stationary
max. usage
for opened
bunches
Hobbock
n.a.
12 month
3 month
can
0,5 l and 1,0 l
n.a.
12 month
3 month
Thermal grease
KP12
KP97
KP98
KP99
KP12
KP97
KP98
KP99
KP12
KP97
KP98
KP99
1K-cartouche*
1 month;
(3 month)**°
6 month;
(12 month)**
1 month;
(3 month)**
3 month;
(12 month)**
1 month
3 month
tube
n.a.
n.a.
1 month;
(3 month)**
3 month;
(12 month)**
syringe
1 – 10 ml
n.a.
n.a.
1 month;
(3 month)**
3 month;
(12 month)**
1 month
3 month
*1K-cartouche = Semco-one coponent cartouches to 30 cc, 75 cc, 180 cc, 360 cc, 600 cc and Euro-cartouches to 310 ml (without integrated mixer)
**() = storage temperature +8 °C bis +12 °C
Transport conditions:
Clean, free of dust and moisture at min. – 40 °C to max. + 50 °C; Make sure there is no condensation on the material before
processing!
General information:
Thermal greases may have a pump out effect, due to temperature variations of the components in operation mode a
migration of the oil in the thermal grease can occur. Therefore the thermal grease is not edaphic and the properties in
application may change (decreasing of thermal conductivity over time, etc.). If thermal greases show a separation they have
to be remixed before usage.
Eschenbach, February 2021
Any specifications contained in preliminary data sheets or R&D reports are based on our present state of knowledge. All statements, technical information and recommendations contained therein are based
on preliminary testing and serve as a guideline only. The final results, and all data derived therefrom, will be published after completion of all product-related testing. This shall not release the purchaser
from his obligation to perform a thorough goods receipt inspection in each case. The recommendations contained herein should be verified by independent tests and trials as there are factors during
processing that our outside our control, in particular when third-party raw materials have been used. Before using any these products, the purchaser must determine the suitability of the selected product for
the intended use, and be aware of any associated risks and potential liability. All product specifications are subject to change in the course of technical progress or internal development. Our
recommendations do not release the customer from his obligation to