Operator Manual Firmware Ver.3.05 and higher Instruction Manual

BOP-1K-GL 022814 1-9
SAVE/RECALL CHARACTERISTICS
(See PAR. 3.5.7)
Number of Locations 99
15 locations available to be implemented on
power-up
Parameters Saved or Recalled All parameters saved for power-up
Mode of operation Voltage, Current or External For External the operating mode is deter-
mined by signal at I/O Port; no signal selects
voltage mode (see PAR. 3.4.1).
Reference type Internal, External or
External Reference Level
Main channel
Internal, External or
Lesser Limit
Limit channel
Main Amplitude
(Internal)
0 to E
O
NOM
or I
O
NOM
(internal or external)
Main Channel:
Voltage (Volts) for Voltage mode,
Current (Amperes) for Current mode
Protection Limit Amplitude
(Internal)
E
O
MIN
or I
O
MIN
to
1.01 E
O
NOM
or I
O
NOM
Limit Channel, Positive and Negative
Voltage (Volts) for Current mode,
Current (Amperes) for Voltage mode
Output status ON or OFF
MISCELLANEOUS FEATURES
Digital Maximum/Mini-
mum Settings
Protection Limit
Type
Bipolar (default) or Independent
Main Channel 0 to E
O
NOM
or I
O
NOM
(default) Software limit to setting of main channel:
Voltage (Volts) for Voltage mode,
Current (Amperes) for Current mode.
Protection Limit Channel
(maximum value, Internal)
E
O
MIN
or I
O
MIN
to
1.01 E
O
NOM
or I
O
NOM
(internal)
Software limit to setting of protection limit
channel:
Voltage (Volts) for Current mode
Current (Amperes) for Voltage mode
Digital Self-test capabilities Serial Interface, Analog, Output Serial Interface test requires Loop Back Test
connector
Digital Interface Settings Data Format SCPI
Output Status @ Reset ON or OFF (OFF = default)
Serial Baud Rate Off, 9600, 19200 (Off = default)
Device Clear SCPI (default) or MATE
XON/XOFF Enable (default) or Disable
Prompt Disable (default), Enable,
Enable with Echo
Digital Calibration Computer-assisted through GPIB or
RS 232 bus
Except analog Voltage Readback with local
manual calibration.
Power-up Settings (top cover accessible
(see Table 2-2)
Allow the unit at power up to:
• Set Load type
• Set the GPIB address
• Set the system configuration for multiple units in series or parallel.
• Enable the analog programming input for main channel and for limit channels.
• Enable the control signal for the mode of operation, voltage or current.
• Set the unit with previously saved custom settings.
• Reset the unit to internal factory default settings, after which the desired power-up
settings must be configured.
TABLE 1-2. BOP GENERAL SPECIFICATIONS (Continued)
SPECIFICATION RATING/DESCRIPTION CONDITION