Manual

BIT 232 022800
2-1
SECTION 2 - INSTALLATION
2.1 UNPACKING AND INSPECTION
The BIT Card has been thoroughly inspected and tested prior to packing and is ready for opera-
tion following installation. Unpack, saving original packing material. If any indication of damage
is found, file a claim immediately with the responsible transport service.
2.2 SET START-UP DEFAULTS (SEE FIGURE 2-2)
Start-up defaults, consisting of Start-up Language and Power Supply Identification are initially
set by means of DIP switches as described in the following paragraphs.
2.2.1 START-UP LANGUAGE DEFAULT (SEE FIGURE 2-2)
DIP switch S1 position 6 sets the Start-up Language Default:
• OFF (0) = SCPI (factory default)
• ON (1) = CIIL
2.2.2 SET POWER SUPPLY IDENTIFICATION SWITCH
(
SEE FIGURE 2-2)
Power Supply Identification switch S2 (Figure 2-2) identifies the BOP model to be controlled by
the BIT Card. Set Switch S2 positions 1 through 6 in accordance with Table 2-1.
2.3 INSTALLATION OF BIT CARD INTO THE BOP
Refer to Figure 2-1 to install the BIT 232-F BIT Card.