Installation Guide

Pencil
Hammer
Safety Goggles
Electric Drill
Phillips Screwdriver
Tape Measure
Level
. Take out the 4 screws at the bottom;
. Install the base plate with the 4 screws;
. Install the bulb into the slot on the mirror.Also take care to
align the recesses(A) of the bulbs and the bulge(B) of the bulb
holder.
. After installing all the bulbs, then connect the adapter and turn
on the power.
NOTE
1. Please install all the bulbs before powering on.
2. Please be careful not to touch the bulb holder directly with your
hands after power is applied to prevent possible electric shock.
3. How to remove the bulb: Turn off the power, hold the bottom of
the bulb tightly and pull it out.
A
B