Installation Guide

5
●Use plug
After hanging the mirror, insert the plug directly into the standard socket.
4. Connect the power. You can use the plug directly or connect the wire
to a standard switch lighting circuit.
3.Mount the bracket to the wall with screws.
DANGER: Before installation, make sure the
main power is cut off.
●Installation hardwired
Cut the plug and connect the mirror's wire to the power by the wire
connectors.
2
1. Important Safety Instructions:
- Please read all instructions carefully before assembling the item.
- Assembly by two or more adults is highly recommended.
- To connect the wires to electrical junction box, a qualified technician
or electrician is highly recommended.
- Disconnect power before installing, adding or changing any
components.
- Ensure that the fixing location is able to take the weight of the
complete fitting. (solid stone / brick walls).
- To prevent injury, the mirror must be installed according to these
instructions.
2. Pre-assembly:
- After opening the package, inspect the product immediately upon
receipt for transit damage or missing parts.
- Keep the voltages between 100V and 120V. If the voltage exceeds 120V,
please use transformer.
- You can connect the wires directly to your junction box or the plug.
Note: Thank you very much for using tetote products, in order to
facilitate the use of tetote products, please read this instruction
carefully before you begin installation.
!
3. Before installation, please check to make sure the mirror is working
properly :
① The left button is the anti-fog touch.
Anti-fog film will automatically turn off one hour of opening.When
you are not using it, remember to turn off the switch to prevent
wasting energy.