Installation Guide

43
-----------------
-------------------
-------------------
----------------------
----------------------
Electric Drill Hammer Marker Pen Tape Measure
Safety GogglesPhillips Screwdriver
Level
Anti-fog touch
Color temperature touch
Light touch
2.Use an electric drill to punch holes at the marked spots, and then
apply wall anchors with hammer.
(1/4” (6mm) drill bit, drilling depth in 1
3/4
” (45mm) )
1.Before installation, please lift the mirror against the wall, keep an
appropriate safety distance from the faucet, confirm the installation
position and installation height of the bracket, use a spirit level to level
the bracket, and mark the hole position on the wall.
The mirror can be hung horizontally or vertically. You can choose the hanging method according to
your preference. Here is the vertical hanging installation method, the horizontal hanging is the same.
Note: Please wear goggles and pay attention to safety.
!
43
!
② The middle button is the color temperature touch.
The first touch is white light, the second touch is yellow light, the third
touch is natural light, and so on. Press and hold it to infinitely adjust the
color temperature.
③ The right button is the light touch.
The first touch is to turn on all the lights, the second touch is to turn on
only the front lights, the third touch is to turn on only the back lights,
and the touch again turns off all the lights, and so on. Press and hold it to
infinitely adjust the brightness.