Instruction Manual

Controlling Audio
87English
Controlling Audio
You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [MENU] button.
 Popup menu appears.
2
Touch [Audio].
See the following section for each
setting.
• Set up Speaker / X’over (P.88)
• Controlling EQ / SW Level (P.90)
• Set Position / DTA (P.94)
• Controlling Fader / Balance (P.90)
• Set Volume Offset (P.91)
• Performing Zone Control (P.92)
• Set Sound Effect (P.93)
• Use Audio Memory (P.95)
3-way speaker system setup
(DDX9907XR / DMX957XR /
DMX907S)
Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
1
Press the [HOME] button.
 HOME screen appears.
2
Touch [ ].
 Source selection screen appears.
3
Touch [STANDBY].
4
Press the button 1 followed by the
button 2 for 1 second at the same time.
DDX9907XR
2 1
DMX957XR / DMX907S
1 2
 Speaker system select screen appears.
5
Select the crossover network mode.
 A confirmation screen appears.
6
Touch [Ye s].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
• When the dual zone is selected and audio source
other than "OFF" is selected as Rear Source, the
speaker system cannot be switched.